MSI H61MA-E35 (B3) - Manual (Page 17)

2-3
Hardware Setup MS-7740
Chapter 2
Screw Holes
When you install the mainboard, you have to place the mainboard into the chassis in the
correct direction. The locations of screws holes on the mainboard are shown as below.
Refer above picture to install standoffs in the appropriate locations on chassis and then
screw through the mainboard screw holes into the standoffs.
Important
• To prevent damage to the mainboard, any contact between the mainboard circuit and
chassis or unnecessary standoffs mounted on the chassis is prohibited.
• Please make sure there are no metal components placed on the mainboard or within
the chassis that may cause short circuit of the mainboard.
Screw holes
The side has to
toward the rear,
the position for
the I/O shield of
the chassis.