MSI X58A-GD45 - Manual (Page 63)

BIOS Setup MS-7522
Chapter 3
3-23
BIOS Setup MS-7522
Chapter 3
CH1/ CH2/ CH3 tRAS
This setting determines the time RAS takes to read from and write to memory cell.
CH1/ CH2/ CH3 tRFC
This setting determines the time RFC takes to read from and write to a memory
cell.
CH1/ CH2/ CH3 tWR
Minimum time interval between end of write data burst and the start of a precharge
command. Allows sense amplifiers to restore data to cells.
CH1/ CH2/ CH3 tWTR
Minimum time interval between the end of write data burst and the start of a col-
umn-read command. It allows I/O gating to overdrive sense amplifiers before read
command starts.
CH1/ CH2/ CH3 tRRD
Specifies the active-to-active delay of different banks.
CH1/ CH2/ CH3 tRTP
Time interval between a read and a precharge command.
CH1/ CH2/ CH3 tFAW
This item is used to set the tFAW timing.
Current CH1/ CH2/ CH3 tdrRdTRd/ tddRdTRd/ tsrRdTWr/ tdrRdTWr/ tddRdTWr/
tsrWrTRd/ tddWrTWr/ tsrRDTRd/ tsrWrTWr
These item show the advanced DRAM timings.
Channel 1/ Channel2 Advanced Memory Setting
Setting to [Auto] enables the advance memory timing automatically to be determined
by BIOS. Setting to [Manual] allows you to set the following advanced memory tim-
ings.
Memory Ratio
This item allows you to set the memory multiplier.
Adjusted DRAM Frequency (MHz)
It shows the adjusted DRAM frequency. Read-only.
Uncore Ratio
This item allows you to set the uncore multiplier.
Adjusted Uncore Frequency (MHz)
It shows the adjusted uncore frequency. Read-only.
QPI Configuration
Press to enter the sub-menu.
QPI Links Speed
This item allows you to select the QPI links speed type.
QPI Frequency
This item allows you to select the QPI frequency.
ClockGen Tuner
Press to enter the sub-menu and the following screen appears.
▶
▶
▶
▶
▶
▶
▶
▶
▶
▶
▶
▶
▶
▶
▶
▶
▶