iRobot Scooba 230 - Manual (Page 2)

iRobot Scooba 230 Quick Start Guide www.irobot.com
Step 3. Set up Scooba
Step 4. Clean Scooba
1 Open both the Fill
and Empty Ports.
Slowly add warm
water in the Fill Port. 2 Add Scooba Hard
Floor Cleaner (either
one pre-measured
packet or one-half
of a cap full). 3 Firmly close the
Fill and Empty
Ports until
sealed.
4 Place Scooba in the
middle of the dirtiest
area of the floor. 5 Press the Power button
to turn on Scooba. 6 For short cycle,
press and hold clean
until second song
plays. (20 minutes,
up to 60 sq. ft.)
For the long cycle, press clean once.
(45 minutes, up to 150 sq.ft.)
1 Empty and thoroughly rinse both the Fill
and Empty Ports with water after each use. 2 Take off the bottom plate. Rinse and
remove debris from brushes and
squeegee. 3 Remove any debris on the robot before
replacing the bottom plate.
© 2011 iRobot Corporation, 8 Crosby Drive, Bedford, MA 01730. All rights reserved. iRobot and Scooba are registered trademarks of iRobot Corporation. [00027.0111.v1]
TIP: To protect bottom plate brushes, keep Scooba on storage mat, when not in use.
TIP: Use only Scooba Hard Floor Cleaner or tap water; other solutions may damage Scooba.
CLEAN
power