Cirrus Logic CDB5366 - Manual (Page 10)

10 DS626DB1
CDB5366
4.2 Switches
The CDB5366 Evaluation Board switches are used for setting speed modes and format protocols and for
resetting devices to their default state. The switch functions are described in
Table 2 .
.
Table 2. CDB5366 Switches
4.3 User Configuration Jumpers
The CDB5366 Evaluation Board jumpers are used for signal routing as shown in Table 3
.
Table 3. User Jumpers
4.4 Reserved Factory Programming Jumpers
The CDB5366 Evaluation Board has two reserved headers, J15 and J8, that are used to factory program
the Cygnal
® 8051 microprocessor and the Xilinx® FPGA so that the FlexGUI interface operates correctly.
Caution! Do not apply power or shorts to these two jumpers as device damage could occur.
.
Table 4. CDB5366 Reserved Jumpers
DESIGNATOR NAME FUNCTION (see CS5366 Datasheet for details)
S1-1 M0 speed mode; Master/Slave function
S1-2 M1 speed mode; Master/Slave function
S1-3 DIF0 Data Format
S1-4 DIF1 Data Format
S1-5 TDM0 Select Channel pairs for S/PDIF output
S1-6 TDM1 Select Channel pairs for S/PDIF output
S4-1 MDIV Master Clock Divider
S4-2 CLKMODE Master Clock Divider
S3 BOARD RESET Resets CS5366, CS8406 and FPGA
S2 PGM Forces FPGA to be loaded with new code (not needed by
user)
DESIGNATOR NAME FUNCTION
J7 CONTROL Select I²C control Source
J91 - Short to ground when not using Crystal
J85 - Short to ground when not using Crystal
J11 OSC/XTL Canned Oscillator/Crystal Selection
J9 +5 V/VA EXT VA source selector
J4 DSP HEADER
DESIGNATOR NAME FUNCTION
J15 MICRO_PROG Reserved interface for pre-programming the Evaluation Board
J8 JTAG Reserved interface for pre-programming the Evaluation Board