WIKA 700.02 - Manual (Page 8)

8
2103869.04 12/2012 GB/D/F/E
GB
WIKA operating instructions differential pressure gauge with piston
C
D
B
B
A
C
D
In processes with floating particles model 700.02 should be used.
Scope of delivery
Cross-check the scope of delivery with the delivery note.
5. Options and accessories
5.1 Mounting flange (only for model 700.01, see left illustration)
May be retrofitted on site as required.
Alignment of the front bezel (A) by means of the stamped cams to the grooves
found on the case circumference. Push front bezel on the case until it snaps into
position.
5.2 Minimum or maximum drag pointer (see illustrations)
The drag pointer (B) serves to monitor and control the miniumum or maximum
occurring differential pressure.
5.3 Reed contact model 851.3 and 851.3.3 (see illustrations)
May be retrofitted and adjusted on site as required.
Fastening is by means of two screws (D) integrated in the reed case (C) on the
display case with the pertinent female thread.
5. Options and accessories