WIKA WUR-1 - Manual (Page 19)

GB
WIKA operating instructions attachable indicator, models A-AS-1, WUR-1 19
2437704.05 10/2012 GB/D/F/E
Error Causes Measures
Err.3
Indication range
exceeded
■ Scaling incorrect ■ The error message will be reset
once the display value is once
more < 9999.
Err.4
Under the indication
range
■ Scaling incorrect ■ The error message will reset itself
once the display value is once
more within the permissible limits.
CAUTION!
If faults cannot be eliminated by means of the measures listed above,
the LED attachable indicator must be shut down immediately, and it must
be ensured that signal is no longer present, and it must be prevented
from being inadvertently put back into service. In this case, contact the
manufacturer. If a return is needed, follow the instructions given in chapter
9.2 "Return".
9. Dismounting, return and disposal
WARNING!
Residual media in dismounted instruments can result in a risk to persons,
the environment and equipment.
Take sufficient precautionary measures.
9.1 Dismounting
Disconnect the LED attachable indicator from the power supply. For plug connections,
loosen the threaded connection and pull apart.
9.2 Returns
WARNING!
Absolutely observe the following when shipping the instrument:
All instruments delivered to WIKA must be free from any kind of hazardous
substances (acids, leachate, solutions, etc.).
When returning the instrument, use the original packaging or a suitable transport package.
8. Faults / 9. Dismounting, return and disposal