7technical specifications, Table 3 includes the technical specifications – Kramer Electronics FC-7501 User Manual
Page 10
KRAMER: SIMPLE CREATIVE TECHNOLOGY
Technical Specifications
8
7
Technical Specifications
Table 3 includes the technical specifications:
Table 3: Technical specifications
1
of the FC-7501 Analog Video to SDI Converter
1 composite
video/Y:
1Vpp/75 looping on BNC connectors with a termination switch
1 (B-Y):
0.7Vpp/75 looping on BNC connectors with a termination
switch
INPUTS:
1 (R-Y)/C:
0.7Vpp/0.3Vpp/75 looping on BNC connectors with a
termination switch
CV, YC:
NTSC (M, Japan, 4.43), PAL (B, D, G, H, I, M, N, Nc) and
SECAM (B, D, G, K, K1, L)
VIDEO STANDARDS:
Component:
50 Hz/625 line, 60 Hz/525 line
OUTPUTS:
2 SDI on BNC connectors
BANDWIDTH:
0.2dB to 5MHz; 1dB to 6MHz
LUMINANCE
NON-LINERARITY:
1% (worst case)
K-FACTOR:
0.1%
S/N RATIO:
57dB (worst case)
CHROMA/LUMA
DELAY:
<10ns
SDI PIXEL JITTER:
<500ps (10Hz HPF) with PLL option board
<1ns (10kHz HPF) without PLL option board
INPUT COUPLING:
DC or AC via internal jumpers
POWER SOURCE:
12 VDC, 320mA
DIMENSIONS:
22cm x 18cm x 4.5cm (8.7" x 7" x 1.7") W, D, H.
WEIGHT:
1.3 kg (2.9 lbs.) approx.
ACCESSORIES:
Power supply
OPTIONS:
19” rack adapter RK-80
8
Communications Protocol for the FC-7501
2
RS-232 communication with the
FC-7501 complies with the following
protocol. The protocol uses 4 bytes of information, and data is at 9600 baud,
with no parity, 8 data bits and 1 stop bit. A null-modem RS-232 connection
should be used between the PC (or other controller) and the
FC-7501. That
is, for a DB-9 port, connect as follows:
Connect pin 5 of the PC to pin 5 of the machine
Cross pins 2 and 3, ie. connect pin 2 of the PC to pin 3 of the
machine, and connect pin 3 of the PC to pin 2 of the machine
On the PC side, short pins 4 and 6
On the PC side, short pins 1, 7 and 8.
1 Specifications are subject to change without notice
2 VER-0.3, 20/01/03.
Download the Communication Protocol
FC-7501 from our Web site at http://www.kramerelectronics.com