Kramer Electronics 466 - Manual (Page 8)

Using the Digital Audio Transcoder
5
4 Using the Digital Audio Transcoder
To connect a single 466 Digital Audio Transcoder machine, as the example in
Figure 3 illustrates 1 , do the following 2 :
1. Connect the sources as follows:
Connect a digital audio source (for example, a DAT player) to the
AES-ID3 INPUT BNC connector
Connect a digital audio source (for example, a DVD player) to the
S/PDIF INPUT RCA connector
Connect a digital audio source (for example, a DVD player) to the
OPTICAL INPUT TosLink® connector
Connect an AES/EBU source (for example, a DAT player) to the
AES/EBU detachable terminal block IN connector using a shielded
twisted pair cable
2. Connect the acceptors as follows:
Connect the OPTICAL OUTPUT TosLink® connector to a digital
audio acceptor (for example, an AV receiver)
Connect the S/PDIF OUTPUT RCA connector to a digital audio
acceptor (for example, an AV receiver)
Connect the AES-ID3 OUTPUT BNC connector to a digital audio
acceptor (for example, a DAT recorder)
Connect the AES/EBU detachable terminal block OUT connector
(using a shielded twisted pair cable) to an AES/EBU acceptor (for
example, a DAT recorder)
3. Connect the 12V DC power adapter to the power socket and connect the
adapter to the mains electricity.
4. Release the TWISTED PAIR/LOCAL button to the LOCAL position.
5. Set the MODE SELECT switch button to PROF. or CONSUMER, as
required (see Figure 2).
6. Press one of the LOCAL INPUT SELECTOR buttons to select an input
source 3 .
This source will appear on all outputs simultaneously.
1 You do not have to connect all inputs and outputs, connect only those that are required
2 Switch OFF the power on each device before connecting it to your 466. After connecting your 466, switch on its power and
then switch on the power on each device
3 If the valid digital audio signal is present on the selected input, the green LINK LED will light