Kramer Electronics 466 - Manual (Page 10)

Cascading Machines
7
5 Cascading Machines
You can cascade several machines via the TWISTED PAIR detachable
terminal blocks (OUT1, OUT2 and IN), to extend the range of the output
signals over several hundred meters.
To use several machines
1 , as illustrated in Figure 4, do the following 2 :
1. Connect the first 466 unit (the Transmitter 3
in Figure 4) as described in
section 4.
2. Connect Receiver 4 # 1 (in Figure 4):
Connect the outputs, as described in section 4 (numbered item 2)
Push in the TWISTED PAIR/LOCAL button to the TWISTED PAIR
position
Connect the TWISTED PAIR OUT 1 detachable terminal block, on
the Transmitter, to the TWISTED PAIR IN detachable terminal
block on Receiver # 1, via a shielded twisted pair cable
Set the MODE SELECT switch button to PROF. or CONSUMER, as
required (see Figure 2)
3. Connect Receiver 4 # 2 (in Figure 4):
Connect the outputs, as described in section 4 (numbered item 2)
Push in the TWISTED PAIR/LOCAL button to the TWISTED PAIR
position
Connect the TWISTED PAIR OUT 2 detachable terminal block, on
the Transmitter, to the TWISTED PAIR IN detachable terminal
block on Receiver # 2, via a shielded twisted pair cable
Set the MODE SELECT switch button on each
466 unit to PROF. or
CONSUMER, as required (see Figure 2)
4. Press one of the LOCAL INPUT SELECTOR buttons to select an input
source 5 . This source will appear on all outputs simultaneously.
If you wish to operate any of the connected units locally, connect the desired
inputs to that unit and release the TWISTED PAIR/LOCAL button to the LOCAL
position.
1 Switch OFF the power on each device before connecting it to your 466. After connecting your 466, switch on its power and
then switch on the power on each device
2 You do not have to connect all inputs and outputs, connect only those that are required
3 This 466 unit is operating as a transmitter in this configuration
4 This 466 unit is operating as a receiver in this configuration
5 If the valid digital audio signal is present on the selected input, the green LINK LED will light