Kramer Electronics FC-10ETH - Manual (Page 15)

12 FC-10ETH - Configuring the FC-10ETH Ethernet Controller
4.3 Defining the Kramer FC-10ETH Manager
Figure 8: FC-10ETH Manager Window
# Feature Function
1
M
e
n
u
B
a
r
DEVICE Search for all connected devices
Upload configuration to device (same as button 4)
SETTINGS Sets the broadcast address and the broadcast network
interface
ABOUT Displays software development information, including the
software version
2 Search Button Seeks the FC-10ETH devices that connect to the PC via the
ETHERNET port, and displays them and their corresponding
settings
3 Device List Displays the MAC Addresses for the FC-10ETH devices,
connected via the selected port (LAN or COM) and the version
(V1 and V2) of the device
4 UPLOAD TO DEVICE Press to upload the displayed configuration to the device
5
FC
-1
0
E
T
H S
e
tt
in
g
FIRMWARE
VERSION Displays the firmware version
6 MAC ADDRESS Displays the MAC Addresses for the FC-10ETH devices,
connected via the selected port (LAN or COM)
7 IP ADDRESS A 32-binary digit number obtained from your Network
Administrator that identifies the FC-10ETH device that is
currently being configured in the Ethernet or Internet
8 SUBNET A 32-binary digit number obtained from your Network
Administrator, which combined with the IP Address, identifies
which network your FC-10ETH device is on
9 GATEWAY A network position serving as an entry to another network or
to the Internet
(only relevant in the Active Routing mode)