Kramer Electronics WP-4iR - Manual (Page 8)

KRAMER: SIMPLE CREATIVE TECHNOLOGY
Connecting the PT-4 iR IR Repeater
6
5 Connecting the PT-4 iR IR Repeater
To connect the PT-4 iR IR Repeater 1 , as illustrated in the example in Figure 4,
do the following:
1. Connect the OUT 2 , 3.5mm mini connector 3 (from 1 to 4) to the following IR
receivers 4 via the IR emitter cable (see Figure 3):
OUT 1 to a DVD player
OUT 2 to a video player
OUT 3 to an amplifier
OUT 4 to a plasma display
2. Connect the 12V DC power adapter to the power socket and connect the
adapter to the mains electricity.
IR Emitter
Figure 3: Connecting the IR Emitter
To operate any of the connected machines, use a remote control 5 pointed to
the IR Repeater 6 that is located at a place of your convenience. The IR signal
from the remote control is transmitted from the PT-4 iR or the WP-4 iR, via
an IR emitter cable, to the appropriate machine.
1 The same procedure applies to the WP-4 iR which is wall-mounted
2 You can connect up to four IR receivers
3 For the WP-4 iR, terminal block connectors are used
4 Stick the IR emitter to the IR receiver window (usually located on the front panel of the video player)
5 You can use a machine’s original remote control or a universal remote control
6 Either the Pico TOOLS PT-4 iR
or the Kramer Wall Plate WP-4 iR