Kramer Electronics SL-10 - Manual (Page 12)

SL-10 - Connecting the SL-10 9
Figure 3: RS-232 Connection
4.3 Connecting the RS-485 Interface
To connect an AV device to the SL-10 using the RS-485 port, connect the RS-485
port on your device to the RS-485 terminal block on the rear panel of the SL-10 as
shown in Figure 4 :
Figure 4: RS-485 Connection
4.4 Connecting the Ethernet Port
The Ethernet connection of the SL-10 allows you to perform all control functions of
the SL-10 over the Internet using a PC running the Kramer Site-CTRL control
program.
To connect the SL-10 to a network:
1. Connect the Ethernet port of the SL-10 to the Ethernet port on a network
hub or network router, via a straight cable with RJ-45 connectors.
2. At the other end, connect the Internet to a PC running Site-CTRL.