Kramer Electronics VP-727A-BA - Manual (Page 17)

Configuring the VP-727A-BA Balanced Audio Switcher
15
6.4.2 Connecting the VP-727A-BA to the VP-727T via the VP-727
To connect the VP-727A-BA to the Kramer VP-727T Presentation Switcher
Control Panel via the RS-485 control port, as illustrated in the example in
Figure 7, do the following:
1. Connect the VP-727A-BA to the VP-727 as follows:
 Connect the “A” (+) PIN on the RS-485 rear panel port of the
VP-727A-BA to the A (+) PIN on the RS-485 rear panel port of the
VP-727 unit
 Connect the “B” (-) PIN on the RS-485 rear panel port of the
VP-727A-BA to the B (-) PIN on the AUDIO CONTROL rear panel
port of the VP-727 unit
 If shielded twisted pair cable is used, the shield may be connected to
the “G” (Ground) PIN on one of the units
2. Connect the VP-727 to the VP-727T as follows:
 Connect the “A” (+) PIN on the RS-485 rear panel port of the VP-727
to the A (+) PIN on the RS-485 rear panel port of the VP-727T unit
 Connect the “B” (-) PIN on the RS-485 rear panel port of the VP-727
to the B (-) PIN on the RS-485 rear panel port of the VP-727T unit
 If shielded twisted pair cable is used, the shield may be connected to
the “G” (Ground) PIN on one of the units
3. On the rear side, slide the SETUP DIP 2 to ON for RS-485 termination.