Kramer Electronics VP-438 - Manual (Page 16)

VP-438 - Controlling the VP-438 13
Mode Function
HDCP ON
OUTPUT Select FOLLOW INPUT or FOLLOW OUTPUT to define whether the HDCP
will follow the input or the output
When FOLLOW INPUT is selected, it changes its HDCP output setting (for
the HDMI output) according to the HDCP of the input. This option is
recommended when the HDMI output is connected to a splitter/switcher
When FOLLOW OUTPUT is selected, the scaler matches its HDCP output
to the HDCP setting of the HDMI acceptor to which it is connected
FACTORY
RESET Resets to the default parameters
If you cannot see the display after factory reset, use the front panel Res. button
to set the correct resolution: press continuously for 2 seconds to reset to XGA, or
continuously for 5 seconds to reset to 720p
INFORMATION Displays the source, the input resolution, the output resolution and the
software version and the H/W version
AUTO SYNC
OFF Turn the auto sync ON/OFF. When ON, a short period after not detecting a
valid video signal on the selected input, the unit will disable the H and V
syncs on the analog outputs until a valid input is again detected or any
keypad button is pressed
EXIT Select to exit the menu
6.2.2 The FINETUNE Menu
The following table defines the FINETUNE menu:
Input Signal Parameter Function
CV,
COMPONENT HUE Set the color hue
SATURATION Set the color saturation
SHARPNESS Set the sharpness of the picture
NOISE REDUCTION Select the noise reduction: OFF, HI, LOW and MID
(middle)
COLOR FILTER Set to ON to enable color filtering
May improve the output image for certain graphic cards
where color fringing is seen
VGA PHASE Set the clock phase
CLOCK Set the clock frequency
H-POSITION Set the horizontal position of the picture
V-POSITION Set the vertical position of the picture
AUTO TUNE When set to ON, automatically centers the picture
correctly on the screen every time the input is switched
to VGA or when the input resolution changes
Alternatively, you can auto adjust the image by pressing
the ENTER button when not within the OSD menu
COLOR FILTER Set to ON to enable color filtering
HDMI COLOR FILTER Set to ON to enable color filtering
DROP LINES Set it to ON to eliminate the green line (default is OFF)
With some sources (mostly Apple devices) a green line
sometimes appears at the bottom of the display. By
factory default this option is set to OFF.
The COLOR FILTER feature may improve the output image for
certain graphic cards where color fringing is seen.
i