Kramer Electronics VP-438 - Manual (Page 12)

VP-438 - Connecting the VP-438 9
5 Connecting the VP-438
Always switch off the power to each device before connecting it to your
VP-438. After connecting your VP-438, connect its power and then
switch on the power to each device.
To connect your VP-438, as illustrated in the example in Figure 3 , do the following:
You do not have to connect all the inputs and outputs, connect only those that are required.
1. Connect an HDMI source (for example, a DVD player) to each of the HDMI
VIDEO INPUT connectors (from 1 to 4).
Alternatively, you can connect the DVI connector on the DVD player to the HDMI
connector on the VP-438 via a DVI-HDMI adapter. When using this adapter, you can
connect the audio signal via the terminal block connector.
2. Connect a computer graphics source to the PC 1 15-pin HD VIDEO INPUT
connector.
3. Connect a composite video source (for example, a composite video player)
to both CV VIDEO INPUT RCA connectors.
4. Connect a component video source (for example, a component video player)
to the COMP 1 P R , P B and Y, VIDEO INPUT RCA connectors.
5. Connect the audio input signals to the AUDIO INPUT terminal block
connectors, as required (not shown in Figure 3 ).
6. Connect the RGBHV VIDEO OUTPUT BNC connectors to an RGBHV
acceptor (for example, an RGBHV display).
7. Connect the HDMI VIDEO OUTPUT connector to an HDMI acceptor (for
example, a plasma display).
8. Connect the VGA VIDEO OUTPUT 15-pin HD connector to a VGA acceptor
(for example, a projector).
9. Connect the audio output signals to the AUDIO OUTPUTS stereo analog
audio acceptor and/or the digital audio acceptor, as required (not shown in
Figure 3 ).
10. Connect the power cord (not shown in Figure 3 ).
i