Kramer Electronics TP-205A - Manual (Page 9)

Configuring the TP-205A
7
7
5.1 Connecting the TP-205A
You can connect the TP-205A to up to five receivers. Use it to transmit the
video, audio and RS-232 control signals via CAT 5 UTP cable.
To connect the TP-205A as illustrated in the example in
Figure 3 , do the
following:
1. Connect an XGA source (for example, a laptop’s graphics card) to the XGA
IN 15-pin HD connector and an audio source to the ANALOG AUDIO IN
3.5mm mini jack 1 , for example, using a Kramer C-GMA/GMA cable
(VGA 15-pin HD (M) +audio jack to VGA 15-pin HD (M) +audio jack) 2
2. Press the SELECT button to select the ANALOG input
.
3
3. Connect an RS-232 cable with a 9-pin D-sub connector at one end to the
laptop, and the other end to the 2 left-hand pins of the terminal block
connector
.
4 (GND and IN) on the TP-205A RS-232 port 5
4. Connect the LINE OUTPUT CAT 5 connectors as follows
.
6
 The LINE OUT 1 RJ-45 connector on the TP-205A to the LINE IN
RJ-45 connector on the TP-124
:
7via UTP cabling 8 (with a range of
more than 300ft (>100m)) 9
 The LINE OUT 5 RJ-45 connector on the TP-205A to the LINE
IN RJ-45 connector on the TP-124 7 , via UTP cabling 8 (with a
range of more than 300ft (>100m))
5. Connect the 12V DC power adapter to the power socket and connect the
adapter to the mains electricity.
6. If necessary, set the H SYNC and V SYNC switches 10
1 Or alternatively to the digital audio S/PDIF IN RCA connector
on the underside.
2 Not supplied. The full list of Kramer cables is on our Web site at http://www.kramerelectronics.com . Alternatively, you can
connect an XGA source to the XGA IN 15-pin HD connector, and a separate audio source to the AUDIO IN 3.5mm mini jack
3 If the digital audio input is selected, release the SELECT button
4 The two right pins (GND and LOOP) can be connected to the GND and IN connectors on an additional TP-205A unit
5 As defined in
Figure 6 and Table 4 (see section 5.3 )
6 You do not have to connect all the outputs
7 Refer to the separate user manual, which can be downloaded from the Internet at
http://www.kramerelectronics.com
8 For details of how to wire a CAT 5 LINE IN/LINE OUT RJ-45 connector, see section 5.3
9 The TP-46 is connected to an additional TP-46 unit for transmitting the signal further
10 By default, both switches are set down (for normal V SYNC and H SYNC polarity)