Kramer Electronics VM-2HDCPxl - Manual (Page 11)

8 VM-2HDCPxl - Connecting the VM-2HDCPxl
When pressing the EDID button briefly, the OUTPUT LEDs indicate which type of
EDID was last acquired. If the:

OUTPUT 1 LED illuminates, the OUTPUT 1 EDID was stored in the
non-volatile memory

OUTPUT 2 LED illuminates, the OUTPUT 2 EDID was stored in the
non-volatile memory

OUTPUT 1 and OUTPUT 2 LEDs illuminate, the Auto-Mix EDID was stored
in the non-volatile memory

OUTPUT 1 and OUTPUT 2 LEDs flash, the Default EDID is stored in the
non-volatile memory
To acquire the EDID, do the following:
1. Connect the power.
2. Connect the output or outputs from which you want to acquire the EDID.
3. Press and hold the EDID button to select the desired EDID.
The OUTPUT LEDs illuminate in the following cycle: OUTPUT 1, OUTPUT
2, both illuminate (auto-mix) and both flash (default).
4. Release the button when reaching the desired set up.
The EDID is now acquired.
If you set the machine to acquire the EDID from an output that is not connected, the
default EDID is acquired.