Kramer Electronics VM-80V - Manual (Page 11)

KRAMER ELECTRONICS LTD.
10
9.5 Operating the VM-80V
Connect a cable from the video sources to the input sockets of the VM-80V.
If a 1:8 operation is needed, press the rear button marked 1:8.
If looping is needed, release the rear termination switch. If looping is not needed, press the switch in to the 75-
Ohm position. If 1:8 operation is selected, one of the termination switches should always be in "Hi-Z" state
(released) and the other according to looping requirements.
Connect up to 8 acceptors to the OUTPUT sockets.
Adjust, if necessary, the trimmers on the front panel of the machine to achieve best results.
Connect a mains power source to the socket on the rear panel of the VM-80V.
Operate source, acceptors and the VM-80V machine.
9.6 Operating the VM-10AN
Connect a video cable from the video source to the video input socket of the VM-10AN and an audio-stereo
cable from the source to the Right and Left Audio inputs sockets.
If looping is needed, release the rear termination switch. If looping is not needed, press the switch in to the 75-
Ohm position.
Connect up to 10 Video / Audio stereo acceptors to the OUTPUT sockets.
Connect the machine to a mains power source with its power cord.
Operate source, acceptors and the VM-10AN machine.
10. TAKING CARE OF YOUR AMPLIFIER
Do not locate your amplifier in an environment where it is susceptible to dust or moisture. These may damage
the electronics, and cause erratic operation or failure. Do not locate your amplifier where temperature and
humidity may be excessive. Do not clean your amplifier with abrasives or strong cleaners. Doing so may
remove or damage the finish, or may allow moisture to build up. Take care not to allow dust or particles to build
up inside unused or open connectors.
11. TROUBLESHOOTING
NOTES
1. Please note that if the output signal is disturbed or interrupted by very strong external electromagnetic interference, it
should return and stabilize when such interference ends. If not, turn the power switch off and on again to reset the
machine.
2. If the following recommended actions still do not result in satisfactory operation, please consult your KRAMER Dealer.