Installation instructions, Hi-o overview prepare strike prepare frame – HES HT1006 User Manual
Page 2

2
Installation Instructions
Hi-O Overview
Prepare Strike
Prepare Frame
1. Prepare frame using the appropriate
template for your lockset and faceplate
combination (see page 8).
2. Connect to system using electrolynx
connectors (see page 3).
3. Install the HT1006 strike body into the
door frame.
4. Set up the Hi-O system (see pages 5-7).
1. Evaluate opening and reset Dip Switch if needed
(see Adjustment Instructions on page 4).
2. For available faceplate options,
see page 9.
ASSA ABLOY’s standard-based Hi-O system—Highly
Intelligent Opening—connects electronic door com-
ponents together over a CAN (Controller Area
Network) data network, allowing them to communi-
cate and monitor the health of the opening. Intelli-
gence is built into each device instead of one central-
ized logic unit, creating a plug-and-play system. Each
device is instantly recognized when plugged into the
system—similar to what happens when a USB device is
plugged into a computer. Every unit is connected with
a four-wire cable and has ElectroLynx® plug-in
connectors for quick installation.
Hi-O is based on devices with built-in intelligence and
a CANbus that links all the devices together. Data
traffic on the Hi-O CANbus can be encrypted. Each
Hi-O device (such as a push plate, electric strike, card
reader, door operator, etc.) is connected to the
CANbus through a single, four-wire cable. Two of the
wires supply power and the other two are used for
data communication.
Refer to the Hi-O Systems Manual (A8002).