Asus A7V133-C - Manual (Page 87)

87
5. SOFTWARE SETUP
ASUS A7V133 User’s Manual
5. S/W SETUP
5.4.1 Installing the Hard Disks
The RAID 0 setting allows users to reformat two hard disks with the same new OS
simultaneously. RAID 1 arrays can use a pre-existing hard disk along with a blank
hard disk, or two new hard disks.
1. Install the first and second hard disk into the hard disk bays of your system.
Connect each hard disk drive with a separate UltraDMA/100 cable, one to the
Primary ATA-100 IDE connector, and the other to the Secondary ATA-100 IDE
connector onboard the A7V133.
2. Ensure that Jumpers 13 and 14 are set for RAID 0 or 1: Jumper 13: [1-2] and
Jumper 14; [2-3] (See Section 3.4.5, Hardware Setup: Motherboard Settings)
3. Connect the power cables to the hard disks.
5.4.2 Enter FastTrak100 BIOS and FastBuild Utility
1. Boot-up your computer. If this is the first time you have booted with two hard
disks correctly installed, then FastTrak100™ “Lite” BIOS scans the IDE
drives and displays this screen:
2 . Press keys to display the FastBuild™ Utility Main Menu:
RAID
FastBuild (tm) Utility 1.31 (c) 1996-2000 Promise Technology, Inc.
Auto Setup . . . . . . . . . . [ 1 ] [ 1 ]
View Drive Assignments . . . . [ 2 ] [ 2 ]
View Array . . . . . . . . . . [ 3 ] [ 3 ]
Delete Array . . . . . . . . . [ 4 ] [ 4 ]
Rebuild Array. . . . . . . . . [ 5 ] [ 5 ]
Controller Configuration . . . [ 6 ] [ 6 ]
Press 1..6 to select Option [ESC] Exit
[ Main Menu ]
[ Keys Available ]