Chemglass CLS-4100-02 - Manual (Page 3)

3
1. Connect the detachable power cord to the AC/DC converter (DC power supply) and connect to “INPUT 24Vdc” receptacle in
rear of unit and then plug power cord into a suitable electrical outlet.
2. Place one or more spinner vessels atop of unit over magnet alignment marks.
SET-UP
(See Figure 1)
24Vdc INPUT Receptacle
Figure 1 Figure 1 Figure 1 Figure 1— — — —Rear Panel Rear Panel Rear Panel Rear Panel
Mains Fuse
1A/250V
Communications Port ( Module
purchased separately ) Optional Motion Alarm
Reset Button
2 Alignment Marks