Attero Tech Control Center - Manual (Page 22)

Control Center
User Manual
 Attero Tech LLC 2013 Page 20 614-00002-07
“SNMP update Failed” message appears in the status bar
o Check the device is still connected to the network. If it is, change the settings again and retry
o Ensure another PC is not attempting to access the same device with metering enabled
Devices do not remember any updated values
o Ensure that after making changes, the Apply button is clicked
o If the device forgets the settings during a power off, ensure that the Persistence setting is on
o If the settings are DSP-related from one of the Device Setup forms, ensure the Save as Default button is pressed to
save the default values to flash