beautypg.com

Assembling your mobile base – SawStop Mobile Base Conversion Kit User Manual

Page 4

background image

4. Take the rear support assembly and move it forward until the two mounting holes align with the next set of holes

in the mobile base frame, as shown in Fig. 4. Mount the rear support assembly to the mobile base frame with

two new M8 x 15.7 shoulder socket screws from the hardware bag. Fully tighten the two M8 x 15.7 shoulder

socket screws with a 5 mm hex key.

Raise

1. N

ever pla

ce fin

ger

s, t

oes

or oth

er

body parts under

the

mob

ile b

ase.

2.

Alway

s us

e th

e saw and the

mob

ile

base

on a leve

l su

rfa

ce.

3. D

o no

t con

tinue

to

step on

the

foot

pedal o

nce the uppe

r limit is rea

ched.

4. L

ower

the s

aw befo

re us

e. N

ever

use

the sa

w when it

is raised off

the floor

.

!

WARNING

Never place finger

s,

toes or other

body parts

under the mobile base.

!

WARN

ING

Never p

lace fin

ger

s,

toes o

r o

ther b

ody

parts

und

er th

e mo

bile b

as

e.

!

WA

RNING

Lower

3 SawStop Mobile Base Conversion Kit

move the rear support

assembly forward until the

two mounting holes align

with the next set of holes

in the mobile base frame

Fig. 5a

Fig. 4

Assembling Your Mobile Base

Never place fingers,

toes or other body parts

under the mobile base.

!

WARN

ING

Raise

. Never place f

inge

rs, toes or

othe

r

body parts u

nder the mobile

base.

2.

Always use

the

saw and the mo

bile

base o

n a level surface.

3. Do not continue

to st

ep on the foo

t

pedal once the up

per limit is reach

ed.

4. Lower th

e saw before u

se. Ne

ver use

the saw when i

t is raised off the f

loor

.

!

WARN

ING

Low

er

Fig. 5b

5. Locate the two conversion linkage bars and the remaining four M8 x 15.7 shoulder socket screws. Use two of

the M8 x 15.7 shoulder screws to install one of the conversion linkage bars on the left side of the mobile base

(see Fig. 5a). The screws pass through the clearance holes in the conversion linkage bar and thread into the

corresponding holes in the rear support assembly and the front bell link. Use the remaining two M8 x 15.7

shoulder socket screws to install the other conversion linkage bar on the right side of the mobile base (see

Fig. 5b). Fully tighten all four screws using a 5 mm hex key.

M8x15.7 shoulder

socket screw

M8x15.7 shoulder

socket screw

M8x15.7 shoulder

socket screws

M8x15.7 shoulder

socket screws

install a conversion

linkage bar on the left

side of the mobile base

install a conversion

linkage bar on the right

side of the mobile base

front

bell link

new

mounting

hole

original

mounting

hole

new

mounting

hole

rear support

assembly