Bell & Gossett V1001576 Suction Diffuser Plus - Manual (Page 12)

1
2
3
4 5
6 7
8
B A
C D
9
• A = To remove diffuser
• B = Distance to support leg
• C = Foot support, not furnished
• D = Support leg, not furnished
Figure 1: Working pressure 175 PSI (1207 KPa), 121°C
(250°F)
1. System
2. Warning label #V56871 installed here. If
missing it must be replaced.
3. Inlet vanes
4. Start-up strainer
5. Orifice cylinder
6. Cover
7. Pump
8. Gauge port
9. Blowdown plug
1
2
3
4
5
Figure 2: Working pressure 300 PSI (2069 KPa), 121°C
(250°F)
1. System
2. Warning label #V56871 installed here. If
missing it must be replaced.
3. Foot support, not furnished
4. Adapter flange
5. Pump
Size Model Number
Dimensions in inches (mm)
A B Part Number C
Schedule 40
Diameter D
2x1.5 BA-3 5.15 (130.8) 3.81 (96.8) A90982 3/4” (19.1)
2x2 BB-3 6.75 (171.5) 4.38 (111.3) A90982 3/4” (19.1)
2.5x2 CB-3 6.75 (171.5) 4.38 (111.3) A90982 3/4” (19.1)
2.5x2.5 CC-3 7.63 (193.7) 5.77 (146.6) A90982 3/4” (19.1)
2.5x2.5 GXF SDG-2.5 7.63 (193.7) 6.60 (167.6) A90982 3/4” (19.1)
3x1.5 DA-3 6.63 (168.3) 4.38 (111.3) A90982 3/4” (19.1)
3x2 DB-3 6.75 (171.5) 4.38 (111.3) A90982 3/4” (19.1)
3x2.5 DC-3 7.63 (193.7) 5.77 (146.6) A90982 3/4” (19.1)
4x2.5 EC-3 7.63 (193.7) 5.77 (146.6) A90982 3/4” (19.1)
3x3 DD-3 8.75 (222.3) 7.02 (178.3) A90883 1–1/4” (31.8)
3x3 GXF SDG-3 8.75 (222.3) 7.66 (194.6) A90883 1–1/4” (31.8)
4x3 ED-3 10.00 (254.0) 7.93 (201.4) A90883 1–1/4” (31.8)
Installation
10 Suction Diffuser Plus INSTRUCTION MANUAL