Rivera Primo Brute II Classic & Classic - Manual (Page 3)

Again, belt free-play should be approximately 3/4” - to- 1” with a cold drive train (not operated for 24 hours). Check belt
up & down play as pictured. If you cannot achieve adequate belt play, call Rivera Primo for advice.
For 11mm belt drive installations (Brute II Classic TM) )free play should
be adjusted via the idler to 3/4” - to - 1” with a cold drive train (not
operated for 24 hours). The idler plate mates with the OEM serrated
plate. TORQUE THE MOUNTING SCREWS TO 29 FOOT
POUNDS.Use Red threadlock on the idler bolt threads & adjust the
idler to give the aforementioned belt play, and tighten in
position.TORQUE THE IDLER BEARING TO 47 FOOT POUNDS.
Do not operate the motorcycle with a belt that is too tight, you may
damage drive train components. Aluminum pulleys expand under the
influence of heat.
Check your belt tension with the drive train at normal operating tem-
perature. The belt should be snug but not “bowstring” tight.
Install the clutch pack exactly the way it was removed from the basket.
.120”steel plate first, then fiber, alternating until all the plates are
installed. Put a dab of high-quality anti-seize on the clutch hub studs
as pictured.
Install the pressure plate as shown with the adjuster screw backed
out most of its thread length.
without idler
(8mm belt )
5
6
7
5A 5B
with idler (11mm belt)
3