Rivera Primo Slimline Belt Drive - Manual (Page 2)

Step 1
Remove chain drive primary & chain housings per O.E.
manual.
Remove grease & dirt from engine, transmission & frame.
Remove bearing race from main shaft using JIMS
fi main
shaft bearing race tool #34902-84. (See figure 1)
Step 2
Insta l l
engine
spacer.
(See
Figure 2)
Step 3
Insta l l
motor plate.
(See figure
2A)
Step 4
Install 4 each 5/16-18 x 1.500 socket head cap screws into
motor plate (engine) using 1 to 2 drops of blue threadlocker
per screw. (See figure 3&4)
Step 5
Tighten all 8 socket head cap screws evenly until
motorplate is seated onto the engine and transmission.
Now torque the 8 socket head cap screws to 28-32 ft. lbs.
Step 6
Reinstall starter reusing the 2 each 5/16-18 x 2.000
socket head cap screws that were in the starter when
removed from O.E. chain housings. (See figure 5)
Note: Disconnect & remove battery from motorcycle
before commencing to work on it.
2
Figure 1
Figure 2A Figure 2
Figure 3
Figure 4
Figure 5