Rivera Primo Brute Force - Manual (Page 5)

STEP 11 :
Using blue threadlock, install the four aluminum stand-offs onto the motor plate assembly. The stand-off with the machined
radius on the bottom goes in the front motor plate section just to the rear of the front pulley.
If your kit came with 5/16” STAND-OFF STUDS, TORQUE THEM TO 29 FOOT POUNDS.
If your kit came with 3/8” STAND-OFF STUDS, TORQUE THEM TO 47 FOOT POUNDS
STEP 12 :
Install the rear pulley bearing retainer (flying saucer shaped)
onto the clutch basket assembly with the six 1/4--20 X 1/2”
bolts provided. Use blue threadlock here.
TORQUE TO 14 FOOT POUNDS
STEP 13 :
Install the front pulley bearing carrier in the front pulley
with the five 5/16-18 X 3/4" bolts supplied. Use blue
threadlock.
TORQUE TO 29 FOOT POUNDS.
MOUNTED STAND-OFFS
2120-0072 two 4.733” long
2120-0073 two 4.367” long
5