Rivera Primo Brute Force - Manual (Page 4)

STEP 8 :
Install the clutch pack into the rear pulley/clutch basket.
The .120” steel plate goes in first, followed by a friction
plate, then a steel plate, alternating until all clutch plates
are installed.
STEP 9 :
Install the pressure plate, diaphragm clutch spring and
spring retainer using the four shouldered nuts (generously
apply anti-seize on the clutch hub stud threads).
Make sure you install the lock clips under nuts. Tighten
the nuts equally until the nuts bottom.
THEN TIGHTEN TO 30 INCH POUNDS, NOT FOOT LBS.
Bend tabs on the lock clips over against nuts.
STEP 10 :
Install the starter support housing using the two
5/16-18 X 3/4" bolts provided.
TORQUE THESE BOLTS TO 29 FOOT POUNDS.
ANTI-SEIZE
4