Rivera Primo Brute IV Extreme Touring 2007 - Manual (Page 2)

motorcase
The motorplate is now ready to install (See figure 7).
NOTE: The shifter shaft support is threaded and can be
removed if forward controls are used instead of the OE
heel/toe shifter.
Remove the oring from the starter pinion gear housing. (See figure 8)
Usng the existing two 5/16-18 SHCS, partially thread then torque per OE specs into the back of the
motorplate to secure the starter and re-tighted the starter motor bracket. (See figure 9b).
Figure 7
Figure 9a F igure 9
Figure 8
Apply two drops of blue threadlocker to the two 5/16-18 X 1 1/2”
SHCS bolts and then attach the starter spacer to the motorplate by
threading the two bolts from starter side of motorplate spacer into
motorplate and torque 25 ft.lbs. (See figure 6).
Figure 6
Figure 8a
Install the stock OE motorcase gasket/spacer ring that came with the
motorcycle over the sprocket shaft and against the motorcase.(See
figure 8a).
Loosen the bracket holding the starter motor in place, then position the motorplate (with the motor-
case spacer & gasket between the motorplate and motor case) over the motor sprocket shaft and
the transmission mainshaft. As you slide the motorplate toward the motor and transmission, slide the
shifter shaft for the heel toe shifter into the shifter shaft support, at the same time fit the motorplate
over the starter motor pinion gear housing. (See figure 9 & 9a). Now slide the motorplate inward
until it is resting firmly against the motorcase and transmission.
Starter Motor Bracket
Figure 9b