Rugged Ridge Winch Cable Stopper, Red - Manual

Winch Cable Stopper (Red /Black)
Page 1
15102.05 / 15102.06 Rev (1) 6/28/2011
Item List:
(1) Cable Stopper (2pcs)
(2) Allen Head Bolt
(2) Flat Washer
(2) Hex Head Nut
Step 1: (Standard Steel Cable)
Place 2pcs cable stopper
over cable just behind cable
swedge.
Step 2: Insert Allen head bolts and press
flat washer into cable stopper
(round opening)
P/N: 15102.05 - Red
15102.06 - Black
Step 1: (Synthetic Rope - 11/32” & 3/8”)
Insert Allen head bolt into one side
of stopper along with hex nut. Start
threads but do not tighten.
Step 1 Step 2 Step 3
Caution
: Cable stoppers have been designed to reduce damage caused by cable hooks making contact with winch hawse
or fairlead when powering in winch cable and hook. Proper winching procedures should be followed at all
times. Hands and fingers should remain clear of hawse or fairlead at all times during cable recovery. Failure to do
so can result in bodily harm. Loose gloves are to be worn at all times when handling recovery cable.
Step 3: Insert hex head nut into Hex
end of stopper. Using 5mm Allen
head wrench secure to cable.
.
Step 2: Slide stopper over rope. Larger
3/8” rope will need to be placed
in the center of stopper and
pressed into center opening
before tightening 2nd bolt.
Step 3: Insert remaining Allen head bolt
washer, and hex head nut into
stopper. Squeeze stopper together
and secure remaining bolt.Tighten
bolts making sure rope remains
centered inside cable stopper.
Step 1: (ATV Cable & Synthetic Rope)
Place 2pcs cable stopper over
cable. (Stopper to slide on cable)
Step 2: Insert Allen head bolts and press
flat washer into cable stopper
(round opening).
Step 3: Insert hex head nut into Hex
end of stopper. Using 5mm
Allen head wrench secure to cable.
Step 1 Step 2
Step 3
Step 1
Step 2 Step 3
.