Rugged Ridge Mesh Roll Bar Top, 07-09 Jeep Wrangler (JK) User Manual
Installing the new summer top
JK Summer Briefs, and Roll Bar Tops
Installation Instructions
2007-09 2DR and 4DR Wrangler
Part Numbers:
13587.XX, 13588.XX, 13589.XX, 13579.01, 13579.02, 13579.03
This product is designed to enhance the
appearance of the vehicle and to shield the
occupants from ordinary weather con-
dictions. Do not rely in any way on the
components of this product to contain
occupants within the vehicle, or to protect
Installation Tips.
against injury or death in the event of an
accident. This top will not protect the
read all instructions thoroughly. Below are
occupants from falling objects. Never
a few tips to make this installation easier.
operate vehicle in excess of manufacture's
After completing the installation, keep
specifications.
these instructions for further reference.
For a Smooth Fit:
Read and follow, precisely, all installation
For ease in installation, the summer top
instructions provided for installing summer tops.
should be installed at a temperature above
Failure to do so may result in a poor fitting
72 F. Below this temperature, the fabric may
top and could place occupants of the
contract an inch or more, making it hard to
vehicle in a potentially dangerous situation.
install. It is normal for the fabric to contract
After installing or reinstalling the summer top,
and wrinkle when stored in the shipping
check to make sure it has been properly
carton. Within a few days of the installation,
installed before driving.
the fabric will relax and the wrinkles will
disappear.
Installing the New Summer Top.
Step (1) :
Insert windshield header into top as shown.
Step (2) :
Secure header to windshield. Follow
This top will work with most aftermarket
the manufactures instructions for
Headers and should not effect fitment.
correct fitment.
Step 1
Step 2
Step 3
Step 4
Step (3) :
Place summer top over center roll bar
Step (4) :
For 4 door models wrap rear summer
(speaker bar) and loop center summer
tops straps over the top of rear cross
top clips around the back side off bar
member and loop through plastic clips
as shown. Push clips up into center bar
as shown. Pull snug, Do Not Tighten.
holes and into steel subframe. Do Not
Tighten at this time. Pull straps only to
keep top in place.For 2doors pull and
attach side straps around roll bar.
Pg.1