Rugged Ridge Upper Door Skin Frames, 97-06 Jeep Wrangler - Manual

Rev. 10/11 Page 1 of 1 SB
13703.80
PLEASE READ AND UNDERSTAND ALL INSTRUCTIONS BEFORE YOU BEGIN.
For Technical Assistance Contact:
OMIX-ADA Tech Support
Phone: 1-800-449-6649
Email: [email protected]
Web: www.Omix-Ada.com
Copyright Omix-Ada 2011
FRAME UPPER DOOR PAIR TJ 97-06
Due to the many variations in body alignments the new upper door frames will
need to be fitted to your vehicle before the upper door skin is attached.
Step 1. Install the upper door frame into the lower half door. Close the half
door and check around the edges of the door frame for alignment. If
adjustments are needed you will have to remove the upper door frame
to make the adjustments. Do not make adjustments with the frame in
the door.
Step 2. To adjust the door frame properly you will need a flat even surface. To
adjust the door frame away from the windshield you will need to stand
the frame vertical on the ground with the windshield side on the ground.
Stand on the lower portion of the frame and using slight force adjust the
frame in the direction illustrated. Adjust the frame in small increments
and test fit after each adjustment until the desired fit is achieved.
Step 3. To adjust the door frame towards the windshield you will need to adjust
in the opposite direction as illustrated using the same procedures as in
step two.