Rugged Ridge Seat Slide/Tilt Lever, 97-02 Jeep Wrangler (TJ) - Manual

Jeep® Seat Adjuster Bracket (Left-Right Seat 1997-2002 TJ)
Page 1
13201.09 Rev (1) 11/11/2010
Important! Please read instructions completely before installing seat adjuster.
Step 1. Remove seat from factory
riser.
Step 2. With seat removed open up
center hole in rear
cross member using a
21/64th drill bit (pic.1)
P/N: 13201.09 TJ Seat Adjuster Bracket
Item List:
(1) Universal Seat Adjuster Bracket (1) M8 Nylock Nut
(1) Universal Seat Adjuster Bar (1) Nylon Spacer
(1) Adjuster Bar Retainer Pin (1) Large M8 Flat Washer
(1) Adjuster Bar Retainer Clevis (1) Small M8 Flat Washer
(1) M8 Bolt
pic.1
Step 3. Note correct orientation for
adjuster bracket to seat
riser. Image shows
passenger (right) side
application. (pic.2)
pic.2
Step 4. Place Nylon spacer
between adjuster bracket
and seat frame. Insert M8
bolt and large flat washer
from bottom. Place small
flat washer and M8 Nylock
nut on top of frame and
tighten. Do Not over
tighten Nylock nut. Adjuster
lever should move freely.
(Pic.3 & 4)
pic. 3
pic.4
Step 6. Insert retainer clevis into top of adjuster bracket.
Install adjuster bar and secure with adjuster bar
retainer pin. (pic.6)
Step 5. Slide notched end of seat adjuster bar into seat riser
actuator bracket as shown (pic.5)
pic.5
pic.6
Step 7. Relocate original seat riser actuator return spring
to small spring hole located on adjuster bracket.
Reconnect spring to seat actuator bracket. (pic.7)
pic.7
pic.8
pic.9
Step 8. Add foam pad to the bottom of adjuster bracket.(pic.8)
Foam pad should be placed between seat riser frame
and bracket.
Step 9: With bracket mounted to seat riser oil all moving and
sliding surfaces. This will insure smooth operation of
new adjuster bracket and seat risers slide and fold
functions. (pic.9)
Step10: Reinstall seat to seat riser. Test function of
seat adjuster bracket (pic.10). Repeat steps
1-10 for other side.
(1) Foam Pad