Rugged Ridge LED Tail Light Assembly, Right Side, 76-06 Jeep CJ & Wrangler User Manual
Page 2
Installation Instructions
LED Replacement Tail Light 12403.82,12403.83
For 76-86 Jeep CJ, 87-06 Jeep Wrangler
- 2 -
Note: LED bulbs draw less current than standard incandescent bulbs. Late model Wranglers (TJ’s)
are equipped with bulb outage circuit detectors that cause the flash rate to increase whenever low
current is detected. Based on your model, you may find it necessary to replace your original turn
signal flasher with an aftermarket unit designed to function with LED’s.
The following are after market flashers that are designed to work with your new LED Tail Lights
87-95 YJ Trico(Tridon) EL-12, 97-00 TJ Trico(Tridon) EP-26,
01-06 TJ Grote 44090 or Trucklite 97283
Step 4: Using a Jeep shop manual, or any other
manual containing the wiring diagram
for your Jeep, determine what wires
operate each function of the tail
lights. Once determined, wire your new
LED tail light.(Fig.7)
Wiring for the LED Tail Light is as follows:
Black wire = parking light
Red wire = stop and turn light
Green = back-up light
Reconnect the battery and check light
operation.
Step 5: Carefully guide the wiring back through
the hole and reinstall the tail lamp
using the factory hardware. Becareful
not to over tighten.
(Fig.8 & 9)
Step 6: Repeat steps 1 thru 5 for the opposite
Side.