Rugged Ridge LED Tail Light Set, 46-75 Willys & Jeep CJ Models - Manual

Installation Instructions
LED Replacement Tail Light 12403.80,12403.81,12403.84
For 46-75 Jeep CJ
- 1 -
NOTE: Because the new LED lights use a larger stud to secure the light assembly, it will be
necessary on some models, to enlarge the existing mounting holes using a 5/16 drill bit and drill.
Step 1: Disconnect the battery.
Step 4: Using a 5/16” drill bit and drill, open
up all mounting holes.
Caution: When drilling, use caution not
to catch any of the wiring
located directly behind the
body panel.
Step 3:
Be careful when pulling the tail
light wiring through the hole.
Disconnect the tail light from the
main wiring.
Step 2: Remove the 2 hex nuts that retain
the tail housing.
Step 5: Wire the tail light using the wiring
code below. Install the tail light and
check for proper function.