Rugged Ridge Inverted Drag Link, 07-14 Jeep Wrangler - Manual

Rev. 9/11 Page 1 of 2 SB
Inverted Drag Link Kit JK
PLEASE READ AND UNDERSTAND ALL INSTRUCTIONS BEFORE YOU BEGIN.
Step 1. Remove the front passenger side tire in accordance with factory owners
manual guidelines. Remove the factory drag link. Remove the nut that
holds the ball joint side of the drag link. Do not discard the nut it will be
reused. Remove the ball joint end from the steering knuckle.
Note: Use of a joint separator may be necessary.
18205.26
Contents:
Drag Link (1)
Tapered Sleeve (1)
Flat Washer 9/16” (1)
Hex Lock Nut (1)
Step 2. Loosen the drag link adjuster sleeve. Unthread the drag link clockwise.
Count the amount of turns it takes to remove the drag link. The new
drag link will need to be installed with the same amount of turns.
Caution: Always park vehicle on level ground when working under vehicle. Eye
protection is required when drilling and working under vehicle.
Penetrating oil may be necessary to remove drag link.
Step 3. Drill out the hole on the knuckle using a 13/16” drill bit. Carefully check
the alignment when drilling to ensure a straight hole.
Step 4. Insert the taper sleeve. You will need to seat the new sleeve into the
knuckle. Use caution when using a hammer to seat the sleeve. Do not
crush the top of sleeve.
Notice: A 13/16” drill bit is required for installation.