Rugged Ridge 2-Inch Coil Spring Spacer Kit, Shocks, 99-04 Jeep Grand Cherokee (WJ) User Manual

Page 3

POST INSTALLATION ChECKS/ALIGNMENT:

• After installation is complete, double check that all nuts and bolts are tight. (Do not retighten nuts

and bolts where Loctite was used.) Check to ensure there is adequate clearance between all
rotating, mobile and fixed members.

• Rotate driveshafts and check for interference at differential yoke and cardan joint. If necessary,

lightly dress casting(s) and/or U-joint tabs in order to eliminate binding.

• Check clearance between inner side wall of tires and links. It may be necessary to adjust
steering stops.

Notice: Adjust drag link so that steering wheel remains centered and wheel sweep from side to side
remains equal. Failure to do so may cause computer errors, odd handling characteristics and poor
performance. Have a qualified alignment center check and realign to factory specifications.

Notice: With vehicle securely elevated, carefully inspect and adjust to assure adequate clearance
between tires (inner side wall), body and suspension components throughout range of steering and
suspension travel. Additionally, carefully inspect and adjust to maintain clearance between suspension

components, wiring harnesses, exhaust, brake and fuel lines, fuel tank, floorboards and body panels.
Complete by properly torquing all fasteners.

Notice:

With vehicle now on floor, again check clearances, cycle steering lock to lock and test proper

brake operation. Raised vehicle height requires realigning headlights. Consult your state’s lighting

regulations. Wheels must be realigned by qualified service center to factory specifications.

Notice: Re-torque fasteners after 500 miles. Thereafter, regularly inspect and re-torque as needed.
Follow vehicle manufacturer’s recommended maintenance procedures and routinely inspect your vehicle
components for unusual wear or off-road damage.

warning: Avoid compromising vehicle handling and safety (including roll over risk) by NOT adding,
combining or fabricating additional lift devices (ex. body lifts) with this product. Also be aware that most

states have restrictions on height modifications for vehicles used on-road. Consult your vehicle owners
manual, the instructions and warnings accompanying this product and state law before undertaking

these modifications or using your modified suspension vehicle on-road. A summary of current regulations

affecting modified suspension vehicles is available from

www.SEMA.org

TEChNICAL ASSISTANCE: Contact Rugged Ridge™ at 770/614-6101 if you have remaining questions
about this product or its installation.

SEAT BELTS SAVE LIVES. PLEASE wEAR yOUR SEAT BELT.