Rugged Ridge 2.5 Inch Lift Kit without Shocks, 07-14 Jeep Wrangler (JK) - Manual (Page 4)

Pg 4
18. Attach new rear bump stops to the factory location on the axle
using the 5/16 x 1" fine thread bolts, washers and nuts supplied.
(See Photo #14) Be sure to install the bump stop so that the
angled end is towards the rear.
19. Let weight on coil springs and re-attach sway bar end links, brake
line and ABS lines. Attach factory track bar to the new bracket in
the lower mounting hole in the new bracket. Upper hole is used
on 4" kits. Attach using the 9/16 x 3" fine thread bolt, washer and
nut. Washer will be used under the nut.
20. Install new track bar bracket brace at axle with supplied diff
cover bolts (See Photo #16).Attach track bar to new bracket
using 9/16 x 3" fine thread bolt, washer and nut. One washer
will be used under the head of the bolt. 4" Kits will use the upper
mounting hole in the new bracket. Be sure to install the bolt from
the front side of the vehicle toward rear of the vehicle.Note: It is
recommended to put a re-enforce weld on the factory track bar
bracket at this time.
21. Install new rear shocks. (See Photo #15)
22. Install tires/wheels and lower vehicle to the ground.
Photo #14
Photo #15
Photo #16