Rugged Ridge 2 Inch Coil Spacer Kit with Shocks, 97-06 Jeep Wrangler (TJ) - Manual

Rev. 5/12 Page 1 of 1 SB
PLEASE READ AND UNDERSTAND ALL INSTRUCTIONS BEFORE YOU BEGIN.
For Technical Assistance Contact:
OMIX-ADA Tech Support
Phone: 1-800-449-6649
Email: [email protected]
Web: www.Omix-Ada.com
Copyright Omix-Ada 2011
Front installation:
1. Secure and properly block the tires of vehicle
on a level hard surface.
2. Jack up front of vehicle and install jack stands
under frame behind the lower link rear brackets.
remove tires and front shocks.
3. Loosen, but DO NOT remove the sway bar end
link’s lower bolts at axle housing on both sides.
Lower front axle down until coil springs become
loose. Remove the bottom bolt and clip from
left front coil spring.
4. Now remove both coil springs. Remove upper
bump stop (use channel lock pliers working
bump stop back and forth).
5. Remove bolt from inside bump stop cup. Install
bump stop spacer and original cup using 10mm
x 50mm long bolts furnished. Reinstall factory
bump stop.
6. Install 2” coil spring isolator pads on top of the
factory pads. Raise jack up so that enough load
is applied to hold the springs in place. Reinstall
spring bolt and clip at bottom of left front coil.
Install new shocks. Completely lower vehicle to
the ground. Now tighten the sway bar endlink’s
lower bolts loosened from step #3
NOTE: Repeat steps 1-6 from above to complete
rear installation.
18415.33
LIFT KIT 2IN POLY TJ