Rugged Ridge Deluxe Carpet Kit with Adhesive, Gray, 76-95 Jeep CJ & Wrangler (YJ) - Manual

P/N: 13690.XX , 13691.XX (without adhesive)
P/N: 13695.XX , 13696.XX (with Adhesive)
Applications: 1976 - 1986 CJ7 and 1987-2006 standard 2dr Wrangler
Jeep® Carpet Kit - Installation Instructions (1976-2006) CJ7 - Wrangler
Contents: (1) Front floor cover
(1) Center floor cover (behind front seats)
(1) Rear floor cover
(2) Fender well covers (LH,RH)
NOTICE: For best results a quality spray adhesive must be used to install this carpet kit.
This adhesive may be found at most large hardware stores or fabric suppliers.
WARNING: DO NOT AIR SHIP CARPET KIT
. Some kits may include
adhesive that can not be shipped via air freight.
Step 1: Remove front and rear seats to ease installation. Clean
all mounting surfaces. Make sure work area is dry before
carpet is installed. If needed remove shift boot covers.
Step 2: Test fit carpet into place as seen in image #1. Make
sure that all carpet pieces are supplied in kit.
NOTICE: Carpet is supplied with no precut holes or notches.
Because of the different variations over the years this
task must be performed at the time the carpet is installed.
WARNING: Before applying spray adhesive make sure that
work area is properly ventilated.
Step 3: Remove carpet and proceed with the installation of the
LH and RH fender well covers. Mark location of side roll
bar and cut only the amount of carpet needed to allow for
a flush fit. Spray back of carpet with adhesive and slide
into place. Repeat for other side.
Step 4: Install rear lower carpet set. Mark hole locations for seat
and seatbelt mounting points. Only cut what is needed to
expose mounting holes. Apply adhesive and slide into
Place.
Step 5: Install center carpet section. Mark seat and seatbelt holes
if needed and only cut what is needed to expose mounting
holes. Apply adhesive and slide into place.
Step 6: Install front carpet section and mark holes as needed for seats
and shifter knobs. Mark holes as shown and only cut what
is needed to expose mounting holes and shift pattern. If
needed cut slits at front LH and RH side tub support brackets.
Make sure carpet does not interfere with pedal operation and
cut to clear if needed. Apply adhesive and slide into place.
reinstall seats and shift boots.
Page 1
PAGE 1
Tools needed:(1) Box knife
(1) Marker
(1) Spray
Adhesive