Rugged Ridge All Terrain Fender Flares, 02-08 Ram 1500, 2500, and 3500 Trucks - Manual

Page 1 of 2
81630.40
2. Clean inside mounting lip edge with rubbing alcohol. Install edge trim as
shown by removing red vinyl tape covering only a few inches at a time. Do not
stretch the trim while being applied, this may cause shrinkage after installation.
Trim excess off.
CONTENTS:
1. Fender Flares (4)
2. M8 Socket Head Cap Crews (38)
3. M8 Flat Washers (38)
4. M8 Locking Hex Nuts (38)
5. U - Clamps (6)
6. Plastic Square Tabs (6)
7. Phillips Head Screws (6)
8. Large Screws (4)
9. Small Clips (4)
Dodge Ram All Terrain Flare Kit
1. Install the supplied trim hardware onto the flares. Place a washer on the bolt
and insert the bolt through the hole in the flare. Place a lock nut on the back
side of the flare to secure the bolt.
3. Remove factory screws located in wheel well housing as indicated in the
image. Install the flare using the factory screws removed. When installing the
flare moderate pressure against the outside of the flare pushing towards the
vehicle will be needed for installation. Repeat this procedure for the other
front flare.
4. Remove the two factory screws located in the rear section of the rear wheel
well. Place the fender flare in place and with a marking pen, mark the top three
mounting holes in the fender well area using the mounting holes in the flare as
a guide. Place two small clips over the 2 factory holes in the front of the wheel
well.
Rev 7/21/10