Rugged Ridge Door Mirror Kit, LED Turn Signals, Black, 87-02 Jeep Wrangler - Manual

WRANGLER LED MIRROR KIT
INSTRUCTION SHEET
Introduction
This mirror kit is designed to enhance
the appearance of your Jeep. This kit
can be used on all Wranglers, with half
and full doors. Some models may
require upper door hinges that are
machined to accept the mirrors. The
mirrors can be wired to operate with
vehicle turn and/or parking lights.
Installation and wiring processes may
vary slightly based upon the model, year,
and door type.
Figure 1. Kit includes one each of RIGHT
and LEFT mirrors, all required wiring and
hardware.
Contents
Right Mirror Assembly - Black or
Chrome
Left Mirror Assembly - Black or
Chrome
Hardware Package –Includes mounting
hardware, wiring and connectors.
Procedure
The appearance, performance and
durability of the installation of these
mirrors will be determined by the work
quality of the installer. The proper tools,
a basic level of understanding and skill,
and a shop manual or wiring diagram
will be beneficial.
Mirror Installation
The mirror assemblies bolt directly to
the upper door hinges on half and full
doors utilizing the same hole locations
that held the OE mirrors. The mirrors
can be installed on other models either
by drilling and tapping the upper door
hinges or installing a pair of upper door
hinges that are already machined to
accept mirrors. The kit can be installed
in a number of possible mounting and
wiring configurations, some more
involved than others. The following
installation was performed on a 1990 YJ.
Figure 2. There is no exposed wiring on the
outside of the vehicle. This requires drilling
holes in the doors and routing wires through
the doors. Less exposed wiring provides a
cleaner look with less chance of snags.
Figure 2 is of an installation that requires
drilling several holes in each door. A
no-drill installation is also possible if
desired. A significant amount of wiring
will be exposed though.