Rugged Ridge Door Mirror Kit, LED Signal, Dual Focus, Black, 87-02 Jeep Wrangler - Manual (Page 3)

Gray/Black, RIGHT into the Brown,
both on the turn signal switch harness.
The colors and locations may be
different on other vehicles. Use the test
light to carefully test and locate the
required wires.
Figure 8. Use the crimp-on splice connector
and spade terminal to make the wiring
connection. The RED (Turn) on the left
mirror is being spliced into the necessary wire
on the turn signal switch harness. The same
splices were done for the remaining turn, and
park wires.
Figure 9. Terminals were crimped onto the
Black ground wires and then they were placed
under existing screws in the metal dash.
Once these connections have been made
the wires can be routed to the right and
left sides of the vehicle; proper length
can be determined, and the plugs can be
installed. Make certain that both the
male and female ends of the plugs are
wired to correspond correctly.
Figure 10. The final installation steps. Be
sure wires correspond on both plugs. Place
wiring in the loom. Tuck plugs behind dash.
Test all light functions.
Figure 11. The initial systems checks proved
that all lighting functioned properly, and our
Jeepin’ buddies were impressed with the cool
new looks.