Rugged Ridge Door Mirror with LED Signals, Black, Right, 07-14 Jeep Wrangler (JK) - Manual

STEP 1.
Remove both OE mirrors.
Mirrors are held in with
two torx bit screws located
on the inside of the door.
Retain OE hardware for
use with new LED mirrors.
Rev (1) 10/13/09
PLEASE READ ALL INSTRUCTIONS BEFORE YOU BEGIN
STEP 2.
With the OE mirror removed, on
the outside of the door, a raised
circular area will be visible. With a
marker, place a mark 1/2 inch
inside the raised circle at the
9 o'clock position. Drill a pilot hole
with a 1/4" drill bit. Make final hole
with a 1/2" drill bit.
STEP 7.
With a marker place a mark
in the lower corner of the
door towards the front
inside of the jeep,
approximately 4 inches up
and 7" over from corner of
door. Drill a pilot hole with
a 1/4" drill bit. Make final
hole with 1/2" drill bit.
Repeat on passenger side.
2007-2010 JK Mirror kit w/ LED turn indicator
FIG 8
Contents:
1- LH LED Mirror
1- RH LED Mirror
1- Wiring Kit
1- Drill
1- 1/2" Drill Bit
1- 1/4" Drill Bit
1- Wire Crimper
1- 3/8" Drive Ratchet
1- T35 Torx Socket
FIG 1 FIG 2
STEP 4.
In the lower square hole,
you will need to drill a 1/4"
angled hole downward through
the bottom of the internal
plastic housing. This will need
to be done on both doors for
routing of the power wires.
FIG 3
Required tools
STEP 6.
Remove both interior door
panels. Note: Interior door
panels are held in with
screws and push pins. Use
caution when removing the
door panels as not crack the
plastic panels.
STEP 8.
Route the red and black wire
through the hole in the outside
of the door and down through
the hole in the plastic housing
and out through the hole on the
inside of lower door section.
When routing the wires do not
route them inside the window
channel as to cause interference
with the power window.
11002.14 11010.14
11002.15 11010.15
11002.22 11010.16
STEP 3.
Repeat the same steps
for marking the passenger
side, with the exception of
the hole will be placed at
the 3 o'clock position.
STEP 5.
Roll up both windows
before continuing.
NOTICE
!
Page 1 of 2