Rugged Ridge Door Entry Guards, Stainless Steel, 07-14 Jeep Wrangler (JK) - Manual

2007 JK Door Entry Guards for 2dr and 4dr. Installation Instructions.
Part Number: 11119.04 - Stainless Steel 2dr.
11119.05 - Stainless Steel 4dr.
11216.10 - Black 2dr.
11216.11 - Black 4dr.
WARNING: It is recommended that the entry guards be
installed with the outside temperature between
52F - 97F (15C - 35C) No rain and low humidity.
4dr version pictured. 11119.05, 11216.11
Step 1: Inspect parts before installation. For both the
stainless steel and black powder coated versions
there should be no visible scathes to the surface.
Step 2: Guards are to be installed only when the outside
temperature is between 52F - 97F and when there
is no rain and low humidity. This will allow the
Adhesive tape to bond strongly to the painted
surface and help to maintain a firm attachment.
Step 3: Using a clean cloth and rubbing alcohol clean
the entry door jam as shown. Make sure all
dirt, oil or any residue is completely removed.
Step 4: Dry door jam with a clean cloth and allow any
alcohol to dry before installing guards.
Place entry guard over door jam and determine
where proper placement will be before proceeding.
Remove red tape backing. CAUTION!
DO NOT touch the adhesive surface of the tape.
This may cause the tape to loose the
ability to properly bond to the door jam.
Step 5: Carefully place the guard onto the door jam. Work
from the outer edge downward. Be very careful
to position the guard correctly. When tape makes
contact with the door jam it will be very difficult to
remove and reposition. TAKE YOUR TIME!
Step 6: Repeat above steps for the other side. For 4door
applications please note that there is a left and
a right side rear entry guard. PLEASE TEST FIT
EACH SIDE PRIOR TO INSTALLING TO
INSURE PROPER FITMENT!
Passenger side rear 4door version. Note how
it is poisoned and also the taper of the guard
Ver#1 6/26/07 Wide side to the front, small side to the rear.