Rugged Ridge Half Doors, Rear, 07-14 Jeep Wrangler (JK) - Manual

Page 1 of 4
JK REAR HALF DOORS
11509.02 JK Rear Half Doors
This product is intended to provide added “off-road” convenience and utility to your vehicle.
This product is not intended to provide occupant containment or protection in the event of an accident or roll-
over. Further, “on road” use may involve increased risk of serious injury in the event of side-impact accidents. To
reduce risk from these types of injuries: Always wear seat belt and shoulder harness for all vehicle occupants.
Keep arms and body inside vehicle. Drive safely, read and understand all manufacturers warnings and product
instructions before installation.
Contents: QTY
1. Half Door (2)
2. Door Hinge (4)
3. M8 Countersunk Bolt (8)
4. Logo (2)
5. Grab Handle (not shown) (2)
6. Grab Handle Mount (not shown) (4)
7. M6 Bolt (not shown) (4)
8. Nylon Door Strap (not shown) (2)
1. Disconnect wiring harness before removing door. Remove
plastic cover at the base of the B-pillar to access the electrical
connector. Release the red locking tab and pull down on the
connector. Next, remove the strap from the hook located inside the
vehicle. NOTICE! Door can swing freely once the strap is released
potentially causing damage to your vehicle. Do not let go of door
when strap is disconnected.
2. Remove the torx nut from the bottom of each factory hinge
pin. Set these nuts aside to be re-installed on the Half Doors. To
remove the factory doors, carefully lift the door upward until the
hinge pins completely clear the hinges. It will be helpful to have
someone else assist with this step.
1 2
3
4