beautypg.com

Rugged Ridge Cold Air Intake Kit, 4.0L, 91-95 Jeep Wrangler (YJ) User Manual

Page 2

background image

4. Install small end of Rubber Elbow onto throttle body using original hose clamp. The Intake Tube can than be

installed onto the large end of the Rubber Elbow using the supplied Hose Clamp.

5. Align Intake Pipe bracket with Rubber Isolator Mount on the Heat Shield and fasten with washer and nut.

Install Air Filter to the end of the Intake Pipe using a supplied Hose Clamp. Note: This filter is polyester synthetic

and never needs to be oiled. It can be cleaned with warm water and mild detergent dish soap.

3. Install Edge Trim onto heat shield and trim to length. Install Rubber Mount to Heat Shield using supplied

hardware

Page 2 of 3