Rugged Ridge Rock Crawler Front Bumper, 76-06 Jeep CJ and Wrangler - Manual

Rock Crawler Classic Front Bumper : P/N 11502.20 (Black)
For 76 – 06 Jeep® CJ and Wranglers
Important notice:
Carefully read instructions before attempting to install this product. Rugged Ridge in no way responsible
for any damage to the vehicle or personal injury that may occur during the installation or use of this
product.
NO DRILLING REQUIRED. Uses existing factory mounting hardware.
Supplied components:
Front bumper p/n: 11502.20 (1)
Spacer washers for CJ models (2)
Installation Instructions:
(Step 1): Remove factory front bumper and save all existing hardware.
A #55 star head bit will be needed to remove Wrangler
mounting bolts.
(Step 2): Install the Classic Rock Crawler front bumper onto vehicle
Using the factory hardware removed in step 1. See step 3
For special CJ application.
(Step 3): CJ application only. For this application there is a gap
between the frame and the mounting bracket. Place the
spacers underneath each side between the frame and
bumper. Use one for each side.
(Step 3): After bumper has been installed and aligned correctly
tighten all mounting bolts.