Rugged Ridge 3-Inch Rear Double Tube Bumper, 55-06 Jeep CJ & Wrangler User Manual
Rugged Ridge For the car

Installation Instructions
52407 Rear Tube Bumper
1955-2006 Jeep CJ, Jeep Wrangler
Page 1 of 1
Please read these instructions completely before attempting to install this
bumper.
Step 1: Attach the bumper brackets to the bumper using the supplied bolts, nuts
and washers. Do not tighten at this time.
Step 2: Place the bumper and brackets up to the rear crossmember. A second
person maybe needed to help hold the bumper in place.
Step 3: Align the bumper left to right as needed. Mark the holes that will best fit
your application and set the bumper and brackets aside.
Step 4: Using a center punch and hammer, mark each hole. This will keep the
drill bit from “walking”. Using a 1/2 “ drill bit, drill the marked holes.
Caution: Be sure to check behind the crossmember for anything that may be
damaged while drilling.
Step 5: To prevent rust, apply a coat of rust preventative paint to the newly
drilled holes. Install the bumper and brackets with the included bolts, nuts and
washers.
Step 6: Align the bumper as needed. Tighten all bolts and nuts when proper
alignment has been achieved.
WARNING: THE HITCH ON THIS BUMPER IS NOT TOW RATED AND
SHOULD NOT BE USED FOR TOWING. IT CAN BE USED FOR HITCH
MOUNTED ACCESSORIES NOT WEIGHING MORE THAN 200LBS.