Rugged Ridge Polished Stainless Steel D-Rings, XHD Modular Front, Rear Bumper - Manual

11540.17
Jeep
®
JK Wrangler Modular HD Front Bumper SS D-Rings
Contents:
1. Stainless Steel D-Rings (2)
2. 12mm Stainless Washer (8)
3. 12mm Stainless Bolt (8)
1. If installing as part of a new installation, place Center Section of Bumper onto frame rails, but do not
yet attach. If SS D-Rings are being added to an existing installation, remove existing D-Rings from
Center Section. Center Section should be sitting on the frame rails, but not attached (Figure 1).
2. Install 8 SS Bolts through the SS Washers, through the SS D-Rings, through the Center Section,
through the Frame Horns, and into the Washers and Lock Nuts provided with Center Section. Do not
tighten any of them yet.
Page 1 of 2
1
2
3
Figure 1
Figure 2a